West London borough with high-value period conversions where quality finishing work — tiling, plastering, decorating — matters most. Hammersmith and Fulham falls well within the West London ground Lian Construction covers on a regular basis. For kitchen renovation work in Hammersmith and Fulham, that local knowledge means fewer surprises once work is on site and a team that already understands the borough's typical property stock.
Hammersmith and Fulham's housing stock is dominated by the kind of period property found across much of inner and West London: Victorian and Edwardian terraces and villas, many of which have been split into flats over the decades, alongside mansion blocks and some purpose-built conversions from the early to mid-20th century. A significant share of the borough's homes are conversions rather than single-family houses, which is typical of high-value West London areas where large period houses have been reworked into two, three or more flats to meet demand. This conversion history means a lot of the existing stock carries older wall and floor build-ups, original plasterwork in varying condition, and layouts that have been altered more than once. As with other West London boroughs, there's also a mix of ex-local authority blocks and post-war infill alongside the period stock. Because so much of the housing is period conversion rather than new-build, quality of finish tends to matter more here than in areas with a higher proportion of modern construction, since old walls, ceilings and floors need careful preparation before tiling, plastering or decorating will look right and last.
In a borough where so much of the property is high-value period conversion, the finishing trades carry more weight than they might elsewhere. A flat carved out of a Victorian terrace lives or dies on how well the plaster, tiling and decorating are done, since buyers and tenants at this end of the market notice uneven walls, poor tile lines or rough paintwork more readily than they would in a standard new-build. That creates steady demand for contractors who can do finishing work properly rather than just quickly, particularly on bathroom and kitchen refits where tiling quality is hard to hide. It also means homeowners and landlords doing up a conversion flat are often better served focusing budget on getting the finishing right rather than cutting corners to save on the last stage of a project. For landlords specifically, a well-finished conversion tends to let faster and at a better rent in this kind of market, so the extra cost of proper plastering and tiling work is usually recovered over time. Given the age and variability of the underlying building fabric, it's also worth budgeting some contingency for making good old walls and floors before the visible finishing work even starts.
Given how much of Hammersmith and Fulham's housing stock is period conversion, it's worth being aware that conservation area and listed building rules are common across this type of West London property, as they are in many inner London boroughs. Converting or altering a period house can trigger planning or listed building consent requirements depending on the specific property and area, particularly for external changes, window replacements or work affecting original features. Internal finishing work like plastering, tiling and decorating is generally more straightforward from a planning perspective, but if it's part of a wider conversion or alteration project it's sensible to check the property's status with the council before starting. As with any older building, it's also worth confirming what internal fabric might be original or protected before stripping back walls, since this can affect both the approach and the cost of the finishing work.
Gas and electrical connections: where the sign-off boundary sits
Kitchens involve more gas and electrical work than almost any other room, and it's worth being clear from the outset about who does what. Our electricians carry out the first and second fix electrical work, running new circuits, positioning sockets above worktop height, wiring extractor fans and under-cabinet lighting, and connecting appliances electrically. Kitchen electrical work is notifiable under Part P of the Building Regulations, and it's tested and certified by a qualified electrician as part of the job, with that certification built into the handover pack. Gas is a different boundary. Where a hob or oven runs on gas, moving or extending the gas supply pipework and the final connection and certification of the appliance itself must be carried out by a Gas Safe registered engineer, not by Lian Construction directly. We coordinate this as part of the overall programme, sequencing the Gas Safe engineer's visit alongside the rest of the second-fix trades so it doesn't hold up the wider job, but the actual gas work and the certificate that confirms it's been done safely comes from that qualified third party, in the same way a structural engineer signs off calculations for a steel beam rather than us doing so ourselves. This isn't a formality we'd cut corners on even if a client asked us to, since an uncertified gas connection is a genuine safety risk and typically invalidates buildings insurance and can hold up a sale later when a buyer's solicitor asks for documentation. If your kitchen is switching from gas to an induction hob, that removes this step entirely for the hob itself, though existing gas pipework being capped off or removed still needs a Gas Safe engineer to do it properly rather than simply being left in place unused.
How kitchen renovation fits with knock-throughs and wider refurbishment work
A kitchen renovation rarely stays entirely within the kitchen's four walls. Where it includes an open-plan knock-through into a dining room or reception room, that structural element is planned and costed as its own phase, with a structural engineer's calculations, a steel beam sized and fabricated to span the new opening, and Building Control involvement running alongside the kitchen fit-out rather than as an afterthought once units are already ordered. Terraced properties bring the Party Wall Act into consideration too where the knock-through affects a wall shared with a neighbour, which needs factoring into the programme early since notice periods and, where required, a party wall award can take several weeks to resolve before structural work can start. Where a kitchen renovation is part of a wider refurbishment, a full house strip-out or an extension, we sequence the kitchen alongside the rest of the programme so first-fix plumbing and electrics happen at the same stage as the rest of the property, rather than as an isolated job that holds up decoration and second-fix work elsewhere. Tiling within a kitchen is delivered to the same standard as our dedicated tiling service, and where a client only wants a new splashback or floor tiled without a full kitchen refit, that smaller scope sits under our tiling service instead of being priced as a full renovation. We also coordinate with plasterboard repair where a wall needs opening up for new pipework or cabling and making good afterwards, and with leak repair where a kitchen renovation follows water damage that needs the affected floor or units properly assessed and, where necessary, replaced rather than fitted straight over a problem that hasn't actually been resolved. Having one team responsible for the whole sequence, from any structural opening through to the last appliance connection, avoids the common problem of a kitchen fitter being booked before a knock-through has even been signed off by Building Control.